Tools:

  • 3mm Allen T-Handle
  • #2 Phillips Screwdriver

 

Process


Place the board on a 5" tall riser  that hangs the wheels off the table. An Amazon box or shoe box will work well.


 


Use the 3mm Allen T-Handle to remove the 6 screws holding on the battery box. Put the 6 screws to the side.

 


When all 6 screws are out, grab around the board holding the un-attached battery box to the deck. Carefully flip it over.

  

 

Grab the battery box and flip it over.

 

 

Notice that the motor wires coming out of the battery box will now be crossed.

 


Use the #2 Phillips Screwdriver to remove the 6 screws that hold the lid onto the battery box.

 

 

There is a light bead of silicon holding the lid to the battery box. Use the box cutter to cut this. Lift the lid off of the battery box.

 


Find the orange battery connector. It will be close to the wall separating the battery and speed controller. Unplug the battery.

 

 

Find the red charge port connector. Unplug the battery from the charge port.

 


Remove the rubber grommet holding the power and charge port wires to the battery box's partition wall.



 

Hold the power connection wire and carefully upwards away from the box.




Remove the battery.

 


Grab your new battery.


Take your battery and place it into the battery box with the power wire pointing towards the speed controller. You should be able to see the label on the battery. If you cannot see the label on the battery, flip it over.




Place the rubber grommet into the battery box wall cutout with the slit side facing up. Direct the battery power and charger wires through the grommet.



Connect the motor power wires to the controller using the yellow connector. When connected, tuck this connected down between the controller and partition wall.



Reconnect the red charge port connection. Notice where the notch is in the male and female sides of this connector. Make sure to interface them correctly.



Once connected, push the charge port connector down between the controller and side wall. Be careful not to pinch, tear, or stress the wires where they attach to the charge port. These wires can be fragile.



Use a Phillips #2 Screwdriver and six lid screws to secure the lid to the battery box.


Notice that the countersinks are only on one side. This side should be facing up.

 


Flip the battery box over.


 


Grab the riser box. Grab the battery box and deck and flip the two, places them on the riser box.

 

 

Use the six battery screws to secure the battery box to the deck. Use a drop of loc-tite on each screws' threads.

 

  

Ready to ride!



abattery