Tools:

  • 3mm Allen T-Handle
  • Utility Knife
  • #2 Phillips Screwdriver

 

Process


Place the board on a 5" tall riser  that hangs the wheels off the table. An Amazon box or shoe box will work well.


 


Use the 3mm Allen T-Handle to remove the 6 screws holding on the battery box. Put the 6 screws to the side.

 


When all 6 screws are out, grab around the board holding the un-attached battery box to the deck. Carefully flip it over.

  

 

Grab the battery box and flip it over.

 

 

Notice that the motor wires coming out of the battery box will now be crossed.

 


Use the #2 Phillips Screwdriver to remove the 6 screws that hold the lid onto the battery box.

 

 

There is a light bead of silicon holding the lid to the battery box. Use the box cutter to cut this. Lift the lid off of the battery box.

 


Find the orange battery connector. It will be close to the wall separating the battery and speed controller. Unplug the battery.

 

 

Find the red charge port connector. Unplug the battery from the charge port.

 


abattery

aunplug