- 1 x Replacement Battery Meter
- 3mm Allen T-Handle
- Utility Knife
- #2 Phillips Screwdriver
- Heat Gun
- Hot Glue Gun (Optional)
Riptide Master Tool Kits can be purchased in our Parts Store here
Place the board on a riser that hangs the wheels off the table. A small box works well.
Use the 3mm Allen T-Handle to remove the 6 screws holding on the battery box. Put the 6 screws to the side.
Grab around the board while supporting the unattached battery box. Carefully flip it over.
Flip over the battery box.
Notice that the motor wires coming out of the battery box will now be crossed.
Use the #2 Phillips Screwdriver to remove the 6 screws that hold the lid onto the battery box.
There may be a light bead of silicon holding the lid to the battery box. Gently grab the motor wires near the back of the battery box and lift up to dislodge the lid. Lift the lid off of the battery box.
Disconnect the battery from the motor controller before working on anything inside the battery box.
Identify where the Battery Meter plugs into the motor controller. Unplug the Battery Meter connector.
Use a heat gun on low heat setting or hair dryer to heat and soften the glue that holds the battery meter in place. Be careful not to apply too much heat to the wall of the battery box, or it will soften and break.
Remove the battery meter by sliding it up and out.
Slide the new battery meter into place.
Use a heat gun on low heat setting or hair dryer to heat and melt the glue and secure the new battery meter in place.
Be careful not to apply too much heat to the wall of the battery box, or it will soften and break.
Plug the battery meter connector into the motor controller. Bend the wiring so that it can be tucked in below the charge port.
Reconnect the battery to the motor controller.
Test the new battery meter by turning power on. Turn power back off using the switch before continuing.
Put the lid back into place. Notice that the countersinks are only on one side. This side should be facing up.
Use the #2 Phillips Screwdriver to tighten the six screws that hold the lid on.
Flip the battery box over.
Grab the board so that you are supporting the unattached battery box. Carefully flip it back over and set it back on top of the riser box used earlier.
Use the 3mm Allen T-Handle to secure the battery box to the deck with the six battery box mount screws. Put a drop of thread lock onto the threads near the end of each screw.
Ready to ride!